Carbon Fiber Molding Processes
Vacuum infusion, autoclave curing, compression molding, and filament winding—our engineers match the right process to your geometry, volume and precision requirements.
- 4 Process Routes
- In-House Tooling
- Batch-Consistent Production
No Single Process Fits Every Part
Oversize components, high-precision parts, small complex shapes and tubes each need a different molding route. We match the process to your part — not the other way around.
WITHOUT PROCESS MATCHING
Design
↓
Guess Process
↓
Compromised Quality
↓
Higher Cost
WITH MATCHED MOLDING
Design
↓
Process Analysis
↓
Right Method
↓
Optimized Cost & Quality
Molding Capabilities
Vacuum Infusion
For large composite structures with dense, low-void construction.
Void Content ≤1.2%
Autoclave Molding
For high-performance, high-precision composite parts.
Performance Variation ≤3%
Compression Molding
For complex small parts and efficient batch production.
8–15 Min / Part
Filament Winding
For tubular and rotational parts requiring high circumferential strength.
Hoop Strength +45%
Which process fits your part?
Size
Large panels and fairings point to vacuum infusion. Smaller parts can use a press.
Precision
Structural or dimension-critical parts go to the autoclave. Appearance-only parts often don't need it.
Volume
High volumes push toward compression molding and its 8–15 minute cycles. Small batches stay on infusion.
Shape
Tubular parts — shafts, tubes, poles — are wound, not laid up.
From Process Selection to Mass Production
Part Review
Geometry, material grade and target volume.
Process Recommendation
Engineer proposes the optimal route.
Tooling & Trial
Mold build and first-article validation.
Mass Production
Standardized process parameters locked in.
Molding FAQ
We support vacuum infusion, autoclave molding, compression molding and filament winding.
For large composite structures requiring low void content
Autoclave molding is suited to high-performance, high-precision composite parts requiring controlled high-temperature and high-pressure curing.
Yes. Forged carbon components can be produced using high-temperature, high-pressure compression molding with a distinctive random-pattern appearance.
Tubes, pipes and high-vibration load-bearing structures.
Based on geometry, tolerance, volume and cost target; we recommend the optimal route for each project.